| A.) |
Wire mesh partition shall be Standard Wire & Works
type No. 135 size group S.
|
| B.) |
10 gauge (.135) steel wire, woven into 1 1/2" diamond mesh,
with wire securely clinched to framing.
|
| C.) |
Wire shall be woven through a horizontal 1" x 1/2" x 12
Ga. channel bar at 3' - 6 1/8" from bottom of partition.
|
| D.) |
Vertical frames 1 1/4" x 5/8" "C" type, cold
rolled channel. Horizontal frames 1" x 1/2" x 12 Ga. channel mortised and
tenoned at intersections.
|
| E.) |
Top capping bar 2 1/2" x 3/4" cold rolled channel with
1/4" "U" bolts approximately 14" O.C.
|
| F.) |
Corner post 1 1/4" x 1 1/4" x 1/8" angle.
|
| G.) |
Cast iron floor shoes 1 1/2" high with set screw adjustment.
|
| H.) |
Door Frames 1 1/4" x 1/2" x 12 Ga. channel with 1
1/4" x 1/8" cover plate on four sides.
|
| I.) |
Sliding doors to have: Two, 4-wheel ballbearing trucks hung in
enclosed box track hung in enclosed box track; cast iron door strike keeper; bottom guide
channel.
|
| J.) |
Hinged doors to have: 1 1/2 pair fast pin butts: continuous 1
3/8" x 7/8" x 1/8" angle strike.
|
| K.) |
3" sweep space under all panels and doors.
|
| L.) |
Aluminum cylinder mortise type locks with
cylinders individually keyed, keyed alike, or master keyed to the building systems. All
locks to have recessed knob on inside (bronze cylinder mortise type locks can be
special ordered).
|
| M.) |
All hardware necessary for proper installation to be furnished.
|
| N.) |
Finish: one shop coat steel gray gloss enamel (or specify other
color if desired).
|
